#Nissan data scan wont let me connect software#

Doing so may result in damage to the ECMs transistor. Pulse signal is measured by CONSULT-II.Р”В¬AUTION: Do not use ECM ground terminals when measuring input/output voltage. Specification data are reference values and are measured between each terminal and ground. Data is for comparison and may not be exact.Р”В®CM Harness Connector Terminal Layout Part 1Р”В®CM Harness Connector Terminal Layout Part 2Р”В®CM Harness Connector Terminal Layout Part 3Р”В®CM Harness Connector Terminal Layout Part 4Р”В®CM Harness Connector Terminal Layout Part 5Р”В®CM Harness Connector Terminal Layout Part 6Р”В®CM Harness Connector Terminal Layout Part 7Р”В®CM Harness Connector Terminal Layout Part 8Р”В®CM Harness Connector Terminal Layout Part 9Р”В®CM Harness Connector Terminal Layout Part 10 Use extreme care not to touch 2 pins at one time. Connect a break-out box (SST) and Y-cable adapter (SST) between the ECM and ECM harness connector. When disconnecting ECM harness connector, loosen it with levers as far as they will go as shown in the figure.Р”В¤. ECM is located in the engine room passenger side behind battery.Р”Р€. Vehicle Powertrain Management Relays and Modules - Powertrain Management Relays and Modules - Computers and Control Systems Engine Control Module Testing and Inspection Pinout Values and Diagnostic Parameters Control Module Pinout ValuesР”РЋ. See the remaining pics.Р”Сћ005 Nissan-Datsun Truck Murano AWD V6-3.5L (VQ35) Once it is disconnected, inspect it for damage to the pins, corrosion, or if one of the pins have been pushed in.Р”Р„s far as the ECM, here are all the pinout values for checking.

#Nissan data scan wont let me connect software#

Now letРІР‚в„ўs start to uninstall and then reinstall the Epson utility, which in most cases will remove Epson software doesnРІР‚в„ўt work properly on Windows 10. Make sure the battery is disconnected before you disconnect or reconnect modules.Р”Р‡irst, make sure the connector is tight. Here if you are using a USB cable to connect an Epson scanner, before reinstalling Epson utility, you would better switch off the scanner and disconnect the cables. If you look at pic 1, it shows the location of the BCM.